Unmanaged Gigabit PoE Network Switch PLANET FGSD-1011HP — 9 x RJ-45 (10/100/1000), 1U rackmount, Blue

PLANET FGSD-1011HP is an unmanaged Gigabit PoE network switch designed for compact rackmount or desktop deployment in small office, retail and surveillance networks. It provides nine RJ-45 Gigabit Ethernet ports with full-duplex operation, integrated Power over Ethernet (802.3af/at) on eight ports, a 4,000-entry MAC address table and a 5.6 Gbit/s switching capacity. The metal 1U form factor and fanless design enable quiet, stable operation while the built-in mini-GBIC slot supports SFP fiber modules for extended uplink distances.

Advantages

The FGSD-1011HP delivers wire-speed packet switching without configuration, combining Gigabit uplinks and multiple PoE+ ports with a total PoE budget suitable for powering IP cameras, access points and other PoE devices. A switchable operation mode set (Standard, VLAN, Extend) provides flexible deployment options: normal PoE operation, port isolation to reduce multicast/broadcast impact, and extended-distance PoE at reduced speed. Built-in ESD protection and a fanless metal enclosure enhance reliability and low-noise operation.

Suitable for

• Small office and home office networks requiring wired Gigabit connectivity
• IP surveillance systems with multiple PoE cameras
• Wireless access point deployments that need centralized PoE power
• Network edge uplinks where fiber SFP extension to backbone is required

Key specifications

• Ports: 9 × RJ-45 10/100/1000 Mbps (8 PoE+ capable)
• Switching capacity: 5.6 Gbit/s
• MAC address table: 4,000 entries
• PoE standards supported: IEEE 802.3af and IEEE 802.3at
• Total PoE power budget: adequate for multiple PoE/PoE+ devices (120 W in typical configuration)
• Operation modes: Standard, VLAN (port isolation), Extend (10 Mbps per-port with up to 250 m PoE distance)
• SFP slot: mini-GBIC supporting 100BASE-FX and 1000BASE-SX/LX modules
• Cooling: fanless, ventilated metal housing
• Weight and form factor: compact 1U/desktop metal housing, approximately 1.22 kg
• Standards: IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.3x
• Color: Blue

How to use

Place the FGSD-1011HP on a stable surface or mount it in a 1U rack. Connect network devices to the RJ-45 ports using Cat5e/6 cables; the ports support auto-negotiation and auto-MDI/MDI-X so no special cable type is required. Install an appropriate SFP transceiver in the mini-GBIC slot if fiber uplink is needed. Use the built-in DIP switch to select Standard, VLAN or Extend mode depending on whether you require normal PoE operation, port isolation to reduce broadcast/multicast impact, or extended-distance PoE at 10 Mbps up to 250 m. Ensure connected PoE devices do not exceed the switch’s total PoE power budget.

Recommendations

For IP camera and wireless AP deployments, plan PoE budget per port and overall load before installation. Use Cat5e or Cat6 for optimal Gigabit performance. When extending power and data beyond 100 m, switch the unit to Extend mode and verify connected devices operate correctly at 10 Mbps. Choose compatible SFP transceivers rated for the required distance and fiber type when using fiber uplinks.