DMX cable EUROLITE XLR 3-pin 5 m, male–female, balanced digital lighting control cable

The EUROLITE DMX cable XLR 3-pin, 5 m is a purpose-built cable for transmitting DMX512 control signals between lighting controllers, dimmers and fixtures. With standard male-to-female XLR connectors and balanced internal wiring, it supports low-latency, interference-reduced transfer of digital lighting data over medium distances. The cable is designed for professional and semi-professional stage, club and event installations where consistent signal integrity is required.

Advantages

The cable uses a balanced three-conductor design to minimise electromagnetic interference and maintain signal quality in electrically noisy environments. Industry-standard 3-pin XLR male and female connectors ensure compatibility with most DMX lighting equipment and consoles. A 5 metre length offers a practical compromise between reach and cable management for typical rigging and floor runs. The construction provides reliable mating and secure retention of connectors during setup and operation.

Suitable for

Key specifications

How to use

Connect the male XLR plug to the DMX output of your controller or previous fixture and the female XLR socket to the DMX input of the next device in the chain. For longer chains, maintain correct termination at the end of the DMX line using a DMX terminator to prevent signal reflections. Route the cable to avoid sharp bends, excessive tension and proximity to heavy power cables to preserve signal integrity. Inspect connectors before use and ensure secure locking when in place.

Recommendations

For stable operation in professional setups, use one cable per DMX run and terminate the final device with a 120 Ω DMX terminator. Avoid coiling the cable tightly around metal trusses or securing it under high compression; use cable ties or clips to form gentle loops and reduce mechanical stress on the connectors.