DMX cable PSSO 3-pin IP65, length 7.5 m

The PSSO DMX cable 3-pin IP65, length 7.5 m is an outdoor-rated connection cable designed to carry DMX512 control signals between lighting controllers and fixtures. Featuring a weather-resistant jacket and sealed 3-pin connectors with IP65 protection, this cable is intended to maintain signal integrity in environments exposed to dust and water spray. Its 7.5 m length provides flexibility for staging and installation layouts while supporting standard DMX signal transmission for entertainment and architectural lighting systems.

Advantages

This DMX cable offers sealed 3-pin connectors that resist dust and water spray, reducing the risk of connection failure in outdoor or damp conditions. The robust outer jacket increases durability against mechanical wear and frequent handling. The fixed length of 7.5 m balances reach and signal quality without the need for intermediate connectors, and compatibility with DMX512 control protocols ensures predictable performance with common lighting consoles and fixtures.

Suitable for

Key specifications

How to use

Connect the cable between the DMX output of the lighting controller and the DMX input of the first fixture, ensuring the 3-pin connectors are fully seated and the sealing surfaces engage. For chain connections, link fixtures using additional DMX cables, maintaining standard daisy-chain topology and observing a single termination resistor at the end of the DMX line if required by the system. Route the cable to minimize sharp bends, pinching, or exposure to heavy foot traffic. After installation, verify signal continuity and correct channel mapping from the controller to each fixture.

Recommendations

For reliable long-term performance, avoid prolonged immersion and do not subject connectors to direct high-pressure water jets. Use appropriate cable management (clips, ties, protective ramps) to prevent mechanical damage, and inspect connector seals periodically for wear. If runs longer than 7.5 m are needed, plan for additional quality DMX cables and proper termination to maintain signal integrity.