SFP+ transceiver module BlueOptics SRX-SFP-10GE-LRM-BO 10000 Mbit/s 1310 nm

The BlueOptics SRX-SFP-10GE-LRM-BO is a 10G SFP+ fiber-optic transceiver designed for multimode fiber links. It supports a maximum data transfer rate of 10000 Mbit/s at a wavelength of 1310 nm and a stated maximum reach of up to 220 m. Housed in a metal casing and powered at 3.3 V, the module is a compact, lightweight (approx. 2 g) SFP+ form-factor transceiver with an LC duplex interface suitable for 10GBASE-LRM applications and compatible hardware platforms that accept LRM SFP+ modules.

Advantages

The module follows MSA SFP+ mechanical and optical standards and provides bidirectional optical transmit and receive functionality at 1310 nm. Its metal housing ensures mechanical robustness and thermal dissipation, while the SFP+ form factor offers hot-pluggable installation and wide compatibility with switches, routers and storage systems that support 10GBASE-LRM transceivers. The product supports diagnostics via the standard digital diagnostic monitoring interface where supported by host equipment and is produced with components intended for long service life.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into an available SFP+ slot on compatible network equipment while the host device is powered down or following the vendor's hot‑swap procedure. Connect an LC duplex multimode fiber patch cord between transceivers on each end of the link, ensuring correct transmit/receive orientation. Verify that the host device supports 10GBASE-LRM and that any required firmware or software settings allow third‑party SFP+ modules and DDM/DOM diagnostics if needed. Monitor link status through the switch/router management interface and use digital diagnostics where supported to check optical power, temperature and supply voltage.

Recommendations

Use high-quality multimode fiber and LC duplex patch cords rated for 10G operation; ensure connectors and patch panels are clean to avoid signal loss. Confirm host compatibility with 10GBASE-LRM SFP+ modules and enable DDM/DOM in host equipment if diagnostic monitoring is required. For extended lifetime and best performance, avoid excessive mechanical stress and maintain appropriate ambient operating temperatures as specified by the host device.