VDSL2 Point-to-Point Bundle ALLNET ALL-MC116VDSL2 Master + Slave PoE pair

The ALLNET VDSL2 Point-to-Point Bundle ALLNET ALL-MC116VDSL2 Master + Slave PoE pair delivers a VDSL2-based copper link solution consisting of a master unit and a slave unit. Designed to extend Ethernet connectivity over existing telephone copper pairs, this bundle combines VDSL2 data throughput with Power over Ethernet (PoE) on the remote unit to power devices such as cameras or access points. The product is intended for point-to-point data links between buildings, remote site connectivity, and CCTV installations where VDSL2 performance and remote powering simplify deployment.

Advantages

The bundle provides synchronized master and slave devices optimized for VDSL2 transmission over copper lines, enabling higher throughput and longer reach than traditional ADSL solutions. Integrated PoE on the slave unit allows powering of remote equipment without separate power cabling, reducing installation complexity and cost. The units are configured to work together out of the box, minimizing configuration time and supporting stable, low-latency links suitable for surveillance and data transport applications.

Suitable for

• Extending network links between buildings over existing copper pairs
• IP CCTV camera connections requiring both data and remote power
• Point-to-point Ethernet links for remote sites or kiosks
• Temporary or permanent deployments where fiber is not available

Key specifications

• VDSL2 transmission over copper telephone pairs
• Master and slave device pair for point-to-point operation
• PoE output on the slave unit to power remote devices
• Designed for Ethernet extension and IP-video transport
• Reduced latency and stable link performance suitable for surveillance

How to use

Install the master unit at the source network location and connect it to the local switch or router via Ethernet. Mount the slave unit at the remote site and connect it to the remote device using the PoE-enabled Ethernet port. Connect the copper pair between master and slave following site cabling standards and ensure correct line polarity. Power the master and slave units according to the manufacturer's instructions and verify link status indicators; typical deployment requires minimal configuration when used as a paired VDSL2 solution.

Recommendations

For best results, use good-quality copper pairs with proper terminations and avoid bridged taps or excessive splices. Place the slave unit in a sheltered location if exposed to weather and verify PoE power class requirements of connected devices to ensure compatibility. Regularly check firmware updates from the manufacturer to maintain interoperability and performance.