SFP transceiver module BlueOptics SFP25G-TR13-BO 25000 Mbit/s SFP28 1310 nm

The BlueOptics SFP25G-TR13-BO is a fiber optic SFP28 transceiver module designed for 25 Gbit/s class links. It supports single-mode fiber transmission at a wavelength of 1310 nm and uses an LC duplex connector for simultaneous transmit and receive channels. The module is lightweight and compact, with a low physical weight of about 20 g, and is engineered for long-distance links of up to 10 000 metres while offering an MTBF rated at 1 000 000 hours for extended operational life.

Advantages

The module provides a 25 000 Mbit/s maximum data transfer rate and is compatible with standard SFP28 interfaces, enabling high-speed optical connectivity for networking equipment. Its single-mode 1310 nm optics and LC connector allow predictable optical performance over long distances. Built to MSA-compatible form factor and with support for digital diagnostic monitoring where supported by host hardware, the transceiver facilitates remote monitoring of key optical and electrical parameters. The compact, silver-coloured housing and low weight make it suitable for dense port deployments and simple handling during installation.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible SFP28 slot on the host device following the hardware vendor’s hot-plug guidelines. Connect the LC duplex single-mode patch cord with correct polarity to the module and the remote transceiver. Ensure the host device firmware or software supports the module and any digital diagnostic monitoring features you intend to use. Verify link negotiation and monitor signal levels and status through the host management interface or supported DDM/DOM functions once the connection is active.

Recommendations

Use single-mode LC duplex patch cables rated for the intended distance, maintain proper polarity on transmit/receive pairs, and confirm host compatibility with SFP28 25G optics and DDM/DOM support for best operational results. Store and handle the module in a dry, clean environment and avoid touching optical interfaces to preserve performance.