Transceiver CBO AGM735 1000Base-SX 850nm multimode fiber optic SFP

The Transceiver CBO AGM735 1000Base-SX 850nm multimode fiber optic SFP is a hot-pluggable Gigabit Ethernet module designed for short-range multimode links. Operating at an 850 nm wavelength, this SFP transceiver provides a standard simplex optical interface for reliable data transmission over multimode fiber cabling. Its compact SFP form factor is compatible with network switches, routers and media converters to extend LAN connections with low latency and stable throughput.

Advantages

This transceiver offers plug-and-play installation thanks to its hot-swappable SFP design and complies with common Gigabit Ethernet optical standards for interoperability. The 850 nm multimode operation enables cost-effective short-distance connections within data centers, wiring closets and campus networks. The module's standard optical interface and industry-compatible form factor simplify replacement and maintenance while supporting stable, low-latency performance for everyday network traffic.

Suitable for

• Short-range Gigabit Ethernet links over multimode fiber in data centers
• Interconnecting switches and routers within enterprise LANs
• Media converters and small form-factor network appliances
• Upgrading or replacing existing multimode SFP ports

Key specifications

• Data rate: 1000 Mbps (Gigabit Ethernet)
• Wavelength: 850 nm
• Fiber type: Multimode fiber (MMF)
• Optical interface: Simplex
• Form factor: SFP (hot-pluggable)
• Typical application: Short-range/shortwave multimode links

How to use

Insert the SFP transceiver into a compatible SFP port on a switch, router or media converter until it clicks into place, then connect the multimode fiber patch cable to the module's optical interface. Ensure the correct orientation and proper seating of the fiber connector to maintain signal integrity. Once installed, verify link status via the host device's port LEDs or management interface. For removal, disengage the locking mechanism and pull the module out gently while following the equipment manufacturer's hot-swap procedures.

Recommendations

Use the transceiver with appropriate multimode fiber (OM1/OM2/OM3/OM4 as supported by your network design) and matched LC connectors to achieve intended link distances. Keep optical ports capped when not in use, avoid contaminating connectors, and follow standard ESD precautions during handling. Verify compatibility with the host device's supported SFP modules and firmware to ensure full functionality.