SFP transceiver module BlueOptics SFP-10G-ZR-PC-BO 10G 1550nm

The BlueOptics SFP-10G-ZR-PC-BO 10G 1550nm is an SFP+ fiber optic transceiver module designed for long-reach, high-speed optical links. It supports a maximum data rate of 10 Gbit/s over single-mode fiber at a wavelength of 1550 nm, uses an LC duplex connector and comes in a compact metal housing. With an input voltage of 3.3 V and a lightweight design, this module is intended for integration into network equipment that accepts SFP+ form-factor modules and requires 10GBASE-ZR class performance for extended-distance Ethernet and other optical protocols.

Advantages

The module delivers 10 Gbit/s performance over long distances up to approximately 10 km (specified maximum transfer distance: 10000 m) while maintaining a small form factor and low weight. Its metal housing provides mechanical durability and thermal stability. The SFP+ interface and LC duplex connector follow common MSA standards, which supports broad compatibility with devices that allow third-party SFP+ transceivers. The transceiver supports digital diagnostics (DDM/DOM) for remote monitoring of parameters such as supply voltage, transmit and receive power and temperature when used in host hardware that exposes these functions.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-10G-ZR-PC-BO into an SFP+ slot on compatible network equipment while the host device is powered down or following the vendor's hot-swap instructions. Connect single-mode fiber with LC duplex connectors between transceivers, ensuring correct transmit/receive orientation. Configure the link speed and protocol on the connected devices according to network requirements (for example 10GBASE-ZR or equivalent). If the host system exposes DDM/DOM, enable or query the diagnostic interface to monitor real-time parameters such as optical power and temperature.

Recommendations

Use single-mode fiber patch cords and LC duplex connectors rated for 1550 nm and verify fiber attenuation and connector cleanliness before deployment. Confirm that the target hardware supports third-party SFP+ transceivers and DDM/DOM functions if remote diagnostics are required. For long-distance links, verify optical link budget and consider using appropriate amplifiers or dispersion compensation only when necessary and supported by network design.