Copper Network Transceiver Module BlueOptics 407-BCZT-BO 1250 Mbit/s RJ-45

The BlueOptics 407-BCZT-BO is a copper SFP transceiver module designed for 1250 Mbit/s data transfer over an RJ-45 interface. Housed in a compact SFP form factor and finished in silver, this module is lightweight (0.02 kg) and intended for integration into standard SFP ports on switches, routers and other network equipment. With an MTBF of approximately 3 million hours, the unit is built for continued operation in typical networking environments and supports the 1000BASE-T electrical standard for copper-based Gigabit connections.

Advantages

The module provides a standard RJ-45 copper interface in an SFP package, allowing flexible port configuration and hot-swappable installation without modifying existing hardware. Its compliance with common SFP mechanical and electrical specifications ensures compatibility with many networking platforms. The compact size and low weight simplify handling and installation, while the stated MTBF indicates extended operational reliability under normal conditions.

Suitable for

• Upgrading SFP slots to copper Gigabit Ethernet connectivity
• Integration into switches, routers and network appliances with SFP ports
• Short-distance connections over standard Cat5e/Cat6 cabling
• Replacement of failed or incompatible copper SFP modules

Key specifications

• Interface type: RJ-45 copper connector
• Maximum data transfer rate: 1250 Mbit/s (1000BASE-T compatible)
• Form factor: SFP (small form-factor pluggable)
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): approximately 3,000,000 hours

How to use

Before installation, power down the target device if recommended by the hardware vendor. Align the SFP module with the SFP slot and insert until it clicks into place; ensure the RJ-45 connector faces outward for cabling. Connect a suitable Ethernet cable (Cat5e or Cat6) to the RJ-45 port and to the remote device. After insertion, verify link status and speed on the host device; configure network settings as required by your environment. To remove the module, follow the device-specific procedure to avoid hot-swap issues and pull the module straight out from the slot.

Recommendations

The BlueOptics 407-BCZT-BO is intended for copper Gigabit applications in supported SFP ports. Use certified Ethernet cabling and follow your hardware vendor's compatibility and firmware guidelines to ensure proper operation. Avoid excessive mechanical force during insertion or removal and operate within the temperature and environmental limits specified by the host device.