SFP+ transceiver module BlueOptics 3FE62600DA-BO Fiber optic 10000 m

The BlueOptics 3FE62600DA-BO SFP+ transceiver module is a fiber optic 10GBASE-LR solution designed for high-speed data transmission over single-mode fiber up to 10,000 metres. Housed in an aluminium enclosure and weighing approximately 20 g, this SFP+ module uses LC duplex connectors and operates with 1310 nm transmitter and receiver wavelengths. It conforms to MSA form-factor standards and supports digital diagnostics for real-time monitoring when used in compatible hardware.

Advantages

The module offers 10 Gbps data rates over long distances with immunity to electromagnetic interference characteristic of fiber-optic links. Constructed to MSA standards, it provides broad compatibility with network equipment that supports 10GBASE-LR SFP+ transceivers. The aluminium housing is lightweight yet durable, and built-in digital diagnostic monitoring (DDM/DOM) enables remote observation of parameters such as temperature, supply voltage, transmit and receive power and laser bias current when the host supports these features.

Suitable for

• 10 Gigabit Ethernet links over single-mode fiber
• Long-reach network connections up to 10 km (metro and campus backbones)
• Interconnection of switches, routers, storage systems and other compatible network hardware
• Environments requiring low-latency, high-bandwidth optical links

Key specifications

• Interface type: SFP+ (10G)
• Optical mode: Single-mode fiber
• Wavelength: 1310 nm (Tx and Rx)
• Connector: LC duplex
• Maximum reach: up to 10,000 m (10 km)
• Housing material/color: aluminium
• Weight: approximately 0.02 kg
• Supports Digital Diagnostics Monitoring (DDM/DOM) when host hardware provides support

How to use

Insert the SFP+ transceiver into a compatible SFP+ port following the host equipment manufacturer's hot‑swap instructions. Connect an LC duplex single‑mode patch cable, ensuring correct TX/RX alignment between transceivers. Verify that the host device recognizes the module and, if available, enable or query DDM/DOM functions through the device management interface to monitor operating parameters. Observe standard ESD precautions when handling the transceiver and protect the optical connectors with dust caps until installation.

Recommendations

For optimal link quality and range, use factory‑terminated single‑mode fiber and high-quality LC patch cords. Ensure the connected network hardware supports 10GBASE‑LR SFP+ transceivers and DDM/DOM if diagnostic monitoring is required. Avoid excessive bend radius on fiber runs and keep connector end faces clean to maintain signal integrity.