SFP transceiver module BlueOptics 1241500000-BO 1250 Mbit/s

The BlueOptics 1241500000-BO 1250 Mbit/s SFP transceiver module is a compact fiber optic interface module designed for 1.25 Gigabit Ethernet links. The module uses an LC (UPC) fiber connector and supports data transmission up to 1250 Mbit/s over multimode or single-mode fiber depending on network setup, with a maximum specified link distance of 2000 m. The module’s SFP form factor and silver housing make it compatible with a wide range of switches, routers and media converters that accept standard SFP transceivers. Its lightweight construction (approximately 20 g) and a mean time between failures (MTBF) of 1,000,000 hours indicate an emphasis on reliability and predictable operational life.

Advantages

The transceiver offers a standardized SFP form factor for hot-pluggable installation, an LC (UPC) fiber connector for secure fiber coupling, and support for up to 1250 Mbit/s throughput suitable for Gigabit Ethernet-compatible links. Its rated maximum link distance of 2000 m supports longer point-to-point connections without intermediate active equipment. The module’s compact size and low weight simplify handling and installation in dense rack or chassis environments.

Suitable for

• Extending Ethernet links between network devices across campus or building segments
• Integration into switches, routers or media converters with SFP slots
• Replacing or upgrading existing SFP transceivers to maintain 1.25 Gbit/s connectivity

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 2000 m
• Ethernet interface type: 1.25 Gigabit Ethernet
• Fiber optic connector: LC (UPC)
• Product colour: Silver
• Weight: 0.02 kg
• Reliability: MTBF 1,000,000 hours

How to use

Before installation, verify that the host device supports SFP transceivers and the required optical interface. Power down the port or follow the host vendor’s hot-swap procedure if supported. Align the LC connector and insert the transceiver into the SFP slot until it latches; then connect the LC fiber cable securely to the module. Configure the host network interface for the appropriate link parameters and verify link status using device diagnostics. If removing the module, disconnect the fiber first and then press the release mechanism to extract the transceiver carefully.

Recommendations

Use clean, certified LC (UPC) fiber patch cables and follow proper fiber handling and safety procedures. Match transceiver wavelength and fiber type to your network design, and consult the host equipment’s compatibility list to ensure firmware and hardware support for third-party SFP modules.