SFP transceiver module BlueOptics 10060H-BO Fiber optic 1250 Mbit/s

The BlueOptics 10060H-BO is an SFP fiber optic transceiver module designed for data transmission at rates up to 1250 Mbit/s. Housed in a compact SFP form factor with a silver finish, this module supports LC (UPC) fiber connectors and is suitable for single-mode links reaching up to 10,000 m. With a lightweight construction (approximately 20 g) and an MTBF of 1,000,000 hours, the module is compatible with networking equipment that accepts 1.25 Gigabit Ethernet SFP interfaces and is intended for consistent, long-distance optical connections.

Advantages

The transceiver offers a standard SFP footprint for broad compatibility with switches, routers and media converters that accept 1.25 Gigabit Ethernet modules. Support for LC (UPC) connectors and single-mode fiber enables long-distance links up to 10,000 m. The silver, compact metal housing provides physical durability while the module’s low weight simplifies handling and installation. An MTBF of 1,000,000 hours indicates a high level of operational reliability for continuous network use.

Suitable for

• Establishing single-mode fiber links between network switches and routers
• Extending network segments over distances up to 10 km
• Use in media converters and SFP-capable access devices
• Replacement or upgrades of existing 1.25 Gigabit Ethernet SFP ports

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 10,000 m (single-mode)
• Ethernet interface type: 1.25 Gigabit Ethernet (SFP)
• Fiber optic connector: LC (UPC)
• Product colour: Silver
• Weight: 0.02 kg
• Form factor: SFP
• Rated reliability: MTBF 1,000,000 hours

How to use

Power down or follow hot-swap procedures for your network device according to the equipment manufacturer’s guidance before installing the SFP module. Align the BlueOptics 10060H-BO with the SFP cage and insert it gently until it latches in place. Connect LC (UPC) fiber patch cords to the module’s ports, ensuring correct transmit/receive orientation. After insertion, verify link status on the host device and configure port settings such as speed and duplex if required by the switch or router. To remove, release the module latch and pull the transceiver straight out, then cap the fiber connectors to protect them.

Recommendations

Use single-mode fiber cabling and LC (UPC) patch cords rated for the intended distance. Confirm compatibility with the host device’s SFP vendor policy and follow electrostatic discharge (ESD) precautions during handling. Regularly inspect and clean connector endfaces to maintain optimal optical performance.