SFP+ transceiver module BlueOptics 02318169-BO 10000 Mbit/s Fiber optic

The BlueOptics 02318169-BO SFP+ transceiver module is a fiber optic pluggable transceiver designed for 10 Gbit/s data transmission over multi-mode fiber. It follows the SFP+ interface standard and features an LC duplex connector. The module is nickel coloured, weighs approximately 20 g and is certified to RoHS, CE, FCC and ISO9001 standards. It is intended for high-speed networking equipment that accepts SFP+ form-factor transceivers and supports optical links up to the module's specified range for 10GBASE-SR operation.

Advantages

This SFP+ transceiver supports a maximum data transfer rate of 10000 Mbit/s and uses multimode optical transmission with 850 nm wavelength components for simultaneous send and receive. The module is produced to MSA-compatible mechanical and electrical specifications for broad interoperability and has been tested for compatibility with relevant hardware platforms. Its lightweight, compact form factor and standard LC duplex connector allow easy installation and replacement in switches, routers and storage systems that accept SFP+ modules.

Suitable for

• 10 Gbit/s Ethernet links over multimode fiber
• High-speed uplinks between switches and routers
• Data centre interconnects and storage network links
• Hardware platforms that support SFP+ pluggable transceivers

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Connector: LC duplex
• Transmission medium: multimode fiber (10GBASE-SR operation)
• Wavelength (typical): 850 nm for transmitter and receiver
• Product colour: nickel
• Weight: approx. 0.02 kg
• Certifications: RoHS, CE, FCC, ISO9001

How to use

Power down or place the host device in a hot-swap safe state if required by the equipment manufacturer, then insert the SFP+ transceiver into an available SFP+ port until it latches. Connect LC duplex multimode fiber patch cords with correct polarity to the module’s duplex LC connector. Ensure the host device is configured for a 10 Gbit/s link and for multimode optics (10GBASE-SR) where applicable. Monitor link status through the host device management interface and, if supported, use the transceiver’s digital diagnostic monitoring (DDM/DOM) features for operational parameters such as optical power and temperature, provided the host supports those functions.

Recommendations

Use multimode OM3/OM4 fiber and quality LC duplex patch cords for optimal reach and signal quality. Verify device compatibility with SFP+ transceivers and confirm that the host supports the DDM/DOM features if remote diagnostics are required. Follow standard ESD handling and installation procedures to avoid damage to the module.