Network Cable Helos FTTH-Anschlussset SC-APC Pre-terminated 372093 2m Black

The Helos FTTH-Anschlussset SC-APC Pre-terminated 372093 2m Black is a factory-terminated fiber optic cable designed for direct installation in fiber-to-the-home and fiber-to-the-desk applications. The assembly comes with SC-APC connectors on pre-terminated ends, a 2 meter black cable jacket and a construction intended to provide low insertion loss and stable single-mode signal transmission for high-speed networks. The ready-made cable reduces installation time and avoids field-termination of delicate optical fibers.

Advantages

The pre-terminated design eliminates the need for on-site splicing or connectorization, enabling faster deployment. SC-APC connectors provide angled physical contact to minimize back reflection, supporting reliable single-mode performance. The 2 m length offers a compact, convenient reach for home and small office installations while the black jacket provides a discreet appearance and mechanical protection. The assembly is suitable for structured cabling where consistent connector quality and low signal degradation are required.

Suitable for

• FTTH connections between optical termination points and devices
• Fiber links in small office and home networks
• Patch connections in fiber distribution panels and wall outlets
• Temporary or permanent fiber runs where a pre-terminated cable simplifies installation

Key specifications

• Connector type: SC-APC on pre-terminated ends
• Cable length: 2 meters
• Mode: single-mode fiber (suitable for FTTH)
• Outer jacket color: black
• Designed for low insertion loss and minimal back reflection

How to use

Route the pre-terminated Helos FTTH cable between the optical termination point and the target device or distribution panel, avoiding sharp bends and excessive tensile load. Insert the SC-APC connector into the corresponding SC-APC receptacle until it seats securely. Verify connector alignment and perform an optical test or link check to confirm low insertion loss and correct signal transmission. If cable management is required, secure the cable with appropriate clips or ties without compressing the fiber.

Recommendations

Handle the SC-APC connectors by the connector body to avoid contamination; use dust caps when connectors are not mated. Maintain minimum bend radius recommended for single-mode fiber and avoid repeated flexing at the cable ends. For best performance, perform end-face inspection and cleaning before connection and validate the link with an optical power meter or suitable test equipment.