Fiber optic transceiver module BlueOptics ONS-SC-GE-LX 1250 Mbit/s 1310 nm

The BlueOptics ONS-SC-GE-LX 1250 Mbit/s 1310 nm is a fiber optic SFP transceiver module designed for use in networking equipment that accept SFP form factors. It supports a maximum data rate of 1250 Mbit/s and transmits at a wavelength of 1310 nm, offering a straightforward solution for single-mode fiber links where stable optical connectivity is required. The module follows standard SFP physical and electrical interfaces for compatibility with a broad range of switches, routers and media converters.

Advantages

This BlueOptics transceiver provides a compact SFP form factor that simplifies installation and saves space in network racks. With support for 1250 Mbit/s and 1310 nm optical transmission, it is suitable for many single-mode fiber deployments and point-to-point links. The module is built to industry specifications to ensure predictable electrical and optical behavior and compatibility with mixed-vendor environments.

Suitable for

• Upgrading switch or router fiber ports to support single-mode links
• Connecting switches and routers over campus or building fiber runs
• Replacing faulty or outdated SFP modules in existing network hardware
• Integrating with media converters for fiber-to-copper conversions

Key specifications

• Form factor: SFP
• Maximum data transfer rate: 1250 Mbit/s
• Operating wavelength: 1310 nm
• Optical fiber type: single-mode (recommended for 1310 nm)
• Typical use: point-to-point optical links

How to use

Install the BlueOptics ONS-SC-GE-LX into an available SFP port on a compatible switch, router or media converter while the host device is powered down or following hot-plug procedures recommended by the hardware vendor. Connect a single-mode fiber cable with appropriate SC connectors to the module, ensuring correct polarity and clean fiber endfaces. After insertion and link-up, verify the link status and data rate through the host device management interface.

Recommendations

Use this transceiver with single-mode fiber and SC connectors at the appropriate link distances for 1310 nm operation. Clean connector endfaces before mating and avoid bending fiber beyond manufacturer-specified radii. Confirm compatibility with your network hardware and firmware to ensure stable operation.