F-angle adapter ShiverPeaks 85210 – F-male to F-female right-angle connector for coaxial cables

The F-angle adapter ShiverPeaks 85210 is an F-male to F-female right-angle connector for coaxial cables, designed to redirect the cable exit by 90° for compact installations. It enables connection of standard F-type coax plugs to devices, wall plates or extension leads where a straight cable would obstruct space or place stress on the connector. The adapter is intended for use with television, satellite and antenna coax runs and is suitable for tightening and aligning connections in confined areas behind equipment or in installation boxes.

Advantages

This right-angle F-type adapter reduces cable bending and mechanical strain at the connector by changing the cable direction without the need to force the cable into a tight radius. Its F-male to F-female configuration preserves the standard threaded connection for reliable electrical contact and easy assembly. The compact right-angle design simplifies wall plate and rear-device installations and helps maintain signal integrity by providing a stable, low-profile connection point.

Suitable for

• TV coaxial connections in living rooms and media cabinets
• Satellite LNB or receiver cable routing where space is limited
• Antenna feeds in lofts, cabinets or behind wall plates
• Installation points requiring strain relief or cable direction change

Key specifications

• Connector type: F-male (plug) to F-female (jack) right-angle adapter
• Orientation: 90° cable exit change
• Compatibility: standard F-type coaxial plugs and jacks
• Application: television, satellite, terrestrial antenna coaxial systems
• Form factor: compact right-angle inline adapter for tight spaces

How to use

Screw the F-male end of the adapter into the device’s F-type socket or wall plate by hand, then attach the coaxial cable with its F-connector to the F-female side by threading it onto the adapter until secure. Ensure connections are tightened sufficiently for good mechanical and electrical contact but avoid over-tightening which could damage connectors. Position the adapter so the cable exits at the required angle and check that the cable routing avoids sharp bends or pinching.

Recommendations

Use the adapter when rear connections are recessed or when direct cable routing would stress connectors; combine with properly sized coaxial cables and quality F-connectors to maintain best signal performance. Inspect threaded connections periodically and replace the adapter if corrosion or mechanical wear is evident.