CBO QSFP 100G multimode transceiver module 850nm — BlueOptics QSFP BO25K13610D

The BlueOptics CBO QSFP 100G multimode transceiver module 850nm (model BO25K13610D) is a hot-pluggable QSFP device that provides 100 Gbit/s multimode optical connectivity at a wavelength of 850 nm. It is intended for short-range links in data center and aggregation environments, supporting high-density QSFP ports and enabling reliable 100G transmission over multimode fiber. The module is compatible with CBO systems and designed to interface with servers, switches and storage equipment where short-reach optics are required.

Advantages

This QSFP multimode transceiver offers high port density and compact form factor for space-constrained racks, enabling 100G links using standardized QSFP interfaces. Operating at 850 nm, it is optimized for short-reach multimode fiber runs and typical data centre topologies. The module supports hot-pluggable installation for minimal service interruption and provides interoperable multimode connectivity for common switching and server platforms.

Suitable for

• Short-range data center uplinks and spine-leaf connections
• Server-to-switch and switch-to-switch aggregation links
• High-density rack deployments requiring 100G multimode optics
• Storage area network interconnects with multimode fiber

Key specifications

• Form factor: QSFP (Quad Small Form-factor Pluggable)
• Data rate: 100 Gbit/s aggregate
• Optical type: Multimode
• Wavelength: 850 nm
• Typical reach: short-range links over multimode fiber (OM3/OM4 dependent)
• Connector type: MPO/MTP multimode fiber connector
• Hot-pluggable: Yes

How to use

Install the QSFP transceiver into a compatible QSFP port on a switch, router or host adapter with the module oriented according to the device’s port markings. Connect the MPO/MTP multimode fiber assembly to the transceiver, ensuring correct polarity and secure latching. Configure the network device per vendor instructions to enable the 100G interface and verify link status. For replacement or upgrades, remove power or follow hot-swap procedures recommended by the equipment vendor, extract the module by the ejector and insert the new transceiver until it latches.

Recommendations

For reliable operation, use multimode fiber rated for high-speed links (OM3 or OM4) and verify fiber polarity and cleanliness before insertion. Observe manufacturer guidelines for electrostatic discharge (ESD) protection and avoid bending the fiber beyond recommended minimum bend radius. Validate compatibility with the host device and perform link tests after installation to confirm expected throughput and signal integrity.