BlueOptics UACC-CM-RJ45-MG-BO network transceiver module Fiber optic SFP+ 30m

The BlueOptics UACC-CM-RJ45-MG-BO network transceiver module is a compact SFP+ solution designed for 10G Ethernet over copper with a maximum range of 30 meters. Housed in an aluminium casing and weighing approximately 20 grams, this module provides a lightweight physical profile suitable for high-density network equipment. It is built to follow MSA standards and is compatible with systems that support the original form factor and electrical interface for 10GBASE-T SFP+ modules.

Advantages

This transceiver offers 10G data transmission over twisted-pair copper cabling while keeping a low weight and robust aluminium housing for durability. Designed to meet common MSA specifications, the module supports broad interoperability with major networking hardware that accepts SFP+ 10GBASE-T copper modules. Production uses industry-grade electronic components to provide long service life and consistent electrical performance.

Suitable for (tasks / use cases)

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on the network device following the device manufacturer’s hot‑swap instructions. Connect an appropriate Category-rated twisted-pair cable (for example Cat6a or Cat7 where applicable) into the module’s RJ45 port, then into the corresponding network port on the peer device. Allow the device to recognize the module and negotiate link speed and duplex. Monitor link LEDs or management interfaces to confirm a stable 10G connection.

Recommendations

Use quality, shielded copper patch cables rated for the required 10G performance and keep cable lengths within the specified 30 m range for reliable throughput. Ensure the host hardware supports 10GBASE‑T SFP+ modules and review firmware compatibility notes from the hardware vendor if automatic negotiation fails.