SFP+ transceiver module CBO SFP-10G-BX10-D 10G 1310nm 10km

The CBO SFP-10G-BX10-D is an SFP+ transceiver module from BlueOptics that delivers 10 Gbps optical connectivity over single-mode fiber using a 1310 nm wavelength. Engineered for compact, hot-pluggable installation in compatible 10G network equipment, this module supports point-to-point links and bidirectional transmission up to 10 km. It is suitable for linking switches, routers and optical line terminals in data centers, campus environments and metropolitan networks where density and reliable high-speed transport are required.

Advantages

This SFP+ transceiver provides a standardized 10G interface with low power consumption and hot-swap capability for easy maintenance and upgrades. The 1310 nm wavelength and single-mode design enable clear signal integrity over distances up to 10 km, while the compact SFP+ form factor conserves space in chassis-based systems. Compatibility with a wide range of 10G ports makes it a flexible choice for expanding or rebuilding fiber links without major equipment changes.

Suitable for

• High-speed uplinks between switches and routers
• Data center server and storage interconnects
• Campus backbone and building-to-building links
• Metro access links and optical networking equipment

Key specifications

• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Maximum reach: up to 10 km over single-mode fiber
• Form factor: SFP+ (hot-pluggable)
• Optical interface: single-mode fiber, bidirectional transmission
• Typical use: 10G Ethernet and compatible optical systems

How to use

Install the transceiver into a compatible SFP+ port on your network device until it clicks into place, then connect single-mode fiber patch cords to the optical interfaces. Configure the connected devices for 10G operation as required by your network equipment (autonegotiation or fixed speed settings). Monitor link status via the host device management interface and perform firmware or configuration updates on the network devices rather than the module itself. For replacement, power down the port if recommended by the equipment vendor, then extract the module using the release mechanism.

Recommendations

Use single-mode fiber with appropriate connectors and clean fiber endfaces before connection to maintain signal quality. Ensure compatible transceiver support in switches and routers and verify link settings after installation. Store spare modules in antistatic packaging and avoid exposing optical ports to dust or moisture.