SFP Transceiver CBO SFP-1G-LH 1G 1310nm single-mode fiber module

CBO SFP-1G-LH is a 1 Gigabit SFP transceiver module designed for single-mode fiber links at a wavelength of 1310 nm. The module provides a compact, hot-pluggable interface compatible with standard SFP ports and is intended for uplink and long-haul point-to-point connections in switches, routers and media converters. It offers straightforward installation, low power consumption and stable optical performance for extended network links.

Advantages

The SFP-1G-LH module supports 1 Gbps data rates over single-mode fiber and delivers reliable signal integrity for long-distance links. Its hot-pluggable SFP form factor enables quick replacement or upgrade without powering down equipment. The transceiver is engineered for compatibility with a wide range of network devices featuring standard SFP ports and provides low power usage to minimize heat generation in rack-mounted systems.

Suitable for

• Uplink connections between switches and routers over single-mode fiber
• Long-haul point-to-point links in campus or metropolitan-area networks
• Fiber extension for media converters and network appliances
• Backbone links requiring 1 Gbps throughput and 1310 nm wavelength

Key specifications

• Nominal data rate: 1 Gbps
• Operating wavelength: 1310 nm (single-mode fiber)
• Optical interface: LC connector (single-mode)
• Form factor: SFP (hot-pluggable)
• Typical reach: long-haul single-mode links (manufacturer guidance applies)
• Power consumption: low, suitable for rack-mounted equipment

How to use

Insert the transceiver into a compatible SFP port on a switch, router or media converter until it clicks into place. Connect a single-mode fiber cable with LC connectors to the optical interface, ensuring correct Tx/Rx orientation. After insertion, verify link/activity indicators and configure device interfaces as required for 1 Gbps operation. For safe removal, power down the port if the host device recommends it or follow hot-swap procedures provided by the equipment vendor.

Recommendations

Use single-mode fiber of appropriate grade and check connector cleanliness before mating. Observe ESD precautions when handling the module and store unused transceivers with protective dust caps. Verify compatibility with host devices' SFP ports and consult equipment documentation for supported optical budgets and link distances.