SFP Transceiver CBO SFP-1G-LH 1G 1310nm 10km

The BlueOptics SFP Transceiver CBO SFP-1G-LH is a single-mode optical module that supports 1 Gbps data transmission over a 1310 nm wavelength with a reach of up to 10 km. Designed for tool-free, hot-pluggable insertion into standard SFP ports, this module provides a compact optical uplink option for switches, routers and media converters. It is intended for network extensions, backbone links and short metro telecom connections where stable single-mode fiber connectivity is required.

Advantages

This SFP transceiver offers compatibility with standard SFP slots and supports hot swap installation for minimal downtime. Operating at 1310 nm and rated for up to 10 km, it delivers a balance of reach and cost-efficiency suitable for many enterprise and carrier access scenarios. The module is compact and energy-efficient, enabling straightforward integration into existing network equipment without additional configuration.

Suitable for

• Fiber uplinks between switches and routers
• Media converter connections to single-mode fiber
• Campus and short metro backbone links
• Telecom access links requiring 1 Gbps capacity

Key specifications

• Data rate: 1 Gbps
• Wavelength: 1310 nm
• Maximum reach: up to 10 km over single-mode fiber
• Form factor: SFP (Small Form-factor Pluggable)
• Connector type: LC duplex
• Power consumption: low-power design (typical for 1G SFP class)
• Operating temperature range: industrial/commercial ranges supported (refer to device datasheet)

How to use

Insert the transceiver into a compatible SFP slot on your network device until it seats firmly and the device recognizes the module. Connect single-mode LC duplex fiber patch cords to the module, observing correct transmit/receive orientation. Configure link settings on connected equipment as needed for 1 Gbps operation; in many cases the link will negotiate automatically. Perform standard fiber handling practices such as cleaning connectors before mating and securing cables to avoid strain on the port.

Recommendations

Use single-mode fiber with appropriate attenuation and route planning for links approaching 10 km. Clean LC connectors before installation, verify polarity, and monitor link status after insertion. For stable operation, ensure SFP port compatibility with third-party transceivers or consult device compatibility notes.