SFP fiber optic transceiver CBO SFP-1G-EX 1 Gbps single-mode 1310 nm, LC

Compact SFP fiber optic transceiver CBO SFP-1G-EX delivers 1 Gbps optical connectivity for single-mode networks using a 1310 nm wavelength and LC duplex connector. The module is hot-pluggable and compatible with typical SFP ports in switches, routers and optical equipment. It is intended for uplinks, long-distance links and telecom environments where a small form-factor transceiver is required to extend network reach and enable cost-effective fiber upgrades.

Advantages

The transceiver supports 1 Gbps data transfer on single-mode fiber and uses standardized LC optical interfaces for broad compatibility. Hot-pluggable design allows replacement or installation without powering down the host device, simplifying maintenance and deployment. Operation at 1310 nm provides an appropriate balance between range and attenuation for long-distance connections in metropolitan and campus networks. The compact SFP form factor reduces space requirements in high-density equipment bays.

Suitable for

• Gigabit uplinks between switches and routers over single-mode fiber
• Long-distance point-to-point links in campus and metro networks
• Telecom access and aggregation where SFP modules are required
• Replacing or upgrading copper ports to fiber in network equipment

Key specifications

• Data rate: 1 Gbps (Gigabit Ethernet/SFP-compatible)
• Fiber type: single-mode fiber (SMF)
• Wavelength: 1310 nm
• Connector: LC duplex optical connector
• Form factor: SFP (hot-pluggable)
• Typical application: uplink and long-distance optical links

How to use

Insert the SFP module into a compatible SFP slot on a switch, router or optical device until it latches; connect LC duplex patch cables to the transmit and receive ports, observing correct polarity. The module is hot-pluggable so it can be installed or removed while the host device is powered. Configure the network interface in the host device as required by your network management system, verifying link status and speed. Ensure the connected fiber is single-mode and that connectors are clean to prevent signal loss.

Recommendations

For reliable operation, use single-mode LC patch cords of appropriate quality, keep optical connectors clean with proper cleaning tools, and verify compatibility with the host equipment’s SFP standards. Confirm link budget and distance requirements for 1310 nm transmission before deployment and avoid bending or stressing the fiber cable near connection points.