SFP Fiber Optic Transceiver CBO AFCT-5765TPZ 1000Base-SX 850nm

CBO AFCT-5765TPZ 1000Base-SX 850nm is an SFP (Small Form-factor Pluggable) fiber optic transceiver designed for short-range Gigabit Ethernet links over multimode fiber. The module supports 1000Base-SX operation at an 850 nm wavelength and provides hot-pluggable connectivity for network equipment such as switches, routers and servers. It is intended for deployment in data center uplinks, campus networks and equipment interconnects where reliable 1 Gbps fiber links are required.

Advantages

This SFP transceiver offers compact form factor compatibility with standard SFP ports and supports hot-swapping without powering down equipment. The 850 nm wavelength and multimode fiber support make it suitable for short-reach links while maintaining Gigabit Ethernet throughput. Its design focuses on interoperability with common network hardware and straightforward integration into existing fiber networks.

Suitable for

• Short-range Gigabit Ethernet links over multimode fiber
• Data center uplinks between switches and aggregation equipment
• Campus and enterprise network horizontal and vertical cabling
• Server-to-switch and switch-to-switch interconnects within the same building

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Data rate: 1 Gbps (1000Base)
• Wavelength: 850 nm
• Fiber type: Multimode fiber (MMF)
• Range: Short-reach links (typical multimode distances as per link budget)
• Connector type: Standard LC duplex
• Hot-pluggable: Yes
• Application: Gigabit Ethernet (1000Base-SX)

How to use

Install the transceiver into a compatible SFP slot on a switch, router or server following the equipment vendor's insertion and removal procedure. Connect multimode fiber using duplex LC connectors and ensure correct transmit-to-receive pairing. After physical insertion and fiber connection, verify link status and speed through the device management interface. For fibre runs, confirm that fiber type and distance fall within the transceiver's supported short-reach parameters.

Recommendations

Use multimode fiber (OM1/OM2/OM3/OM4 as appropriate) with proper patch cords and maintain clean LC connectors. Verify vendor compatibility with the host device and avoid exceeding recommended cable distances for 850 nm 1000Base-SX operation. Handle the SFP module carefully during insertion and removal to prevent damage to the optical interface.