BlueOptics JNP-QSFP-4X10GE-LR-BO network transceiver module 40000 Mbit/s OSFP

The BlueOptics JNP-QSFP-4X10GE-LR-BO is a 40 Gbit/s network transceiver module in QSFP form factor with an OSFP interface, designed for high-density, long-reach optical connections. It implements 40GBASE-PLR4 transmission using an MPO/MTP multi-fiber connection and supports simultaneous transmit and receive operation at 1310 nm. The module is built to MSA-compliant specifications and includes digital diagnostics monitoring (DDM/DOM) for real-time status reporting of voltage, temperature, laser power and related parameters. With an indicated MTBF of 3,000,000 hours and a compact, silver-coloured housing, the transceiver is intended for reliable use in switches, routers and storage systems that accept QSFP/OSFP-compatible modules.

Advantages

This BlueOptics module offers 40 Gbit/s aggregated bandwidth with MPO/MTP connectivity suitable for parallel optics links, enabling low-latency data transmission over multimode fiber. Compliance with MSA standards and use of tested components ensure interoperability with common networking platforms. Integrated DDM provides diagnostic data for easier troubleshooting and maintenance. The compact QSFP form factor and OSFP interface support high-density installation in modern network equipment while the stated MTBF and component selection aim to deliver long service life and reduced maintenance intervals.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible QSFP/OSFP slot on the network device following the vendor's hot-plug procedures. Connect an MPO/MTP multi-fiber patch cable to the module and route the fiber to the corresponding MPO/MTP port or patch panel. Ensure the host equipment supports the 40GBASE-PLR4 protocol and, if required, enable or verify DDM/DOM support in the system for monitoring. Power up the host device and verify link status and optical parameters through the host management interface or the module's diagnostic readouts.

Recommendations

Use factory-quality MPO/MTP patch cables matched to the module's fiber type and maintain proper fiber polarity. Verify compatibility with the specific switch or router model before deployment and enable DDM/DOM where supported to monitor optical power and temperature. Avoid bending the fiber beyond recommended radii and follow ESD precautions when handling the transceiver to preserve longevity and performance.