Fiber Optic Transceiver CBO GSLC110-EZX 1000Base-SX 850nm

The BlueOptics Fiber Optic Transceiver CBO GSLC110-EZX 1000Base-SX 850nm is a hot-pluggable SFP module designed for gigabit Ethernet over multimode fiber. It supports 1000Base-SX operation at an 850 nm wavelength, enabling short-range optical links between switches, servers and storage equipment in data centers and enterprise LANs. The module follows standard SFP form factor and electrical interfaces for straightforward installation in compatible networking equipment.

Advantages

This transceiver offers compact SFP size with plug-and-play installation, compliance with 1000Base-SX optical specifications, and operation optimized for multimode fiber at 850 nm. It provides low power consumption and reliable signal integrity for short-reach links, and its industry-standard interface ensures compatibility with a wide range of switches and transceiver cages.

Suitable for

• Short-range gigabit Ethernet links in data centers
• Interconnects between network switches and server NICs
• Enterprise LAN backbone segments over multimode fiber
• Storage area network connections requiring optical SFP modules

Key specifications

• Supported standard: 1000Base-SX (Gigabit Ethernet)
• Wavelength: 850 nm
• Form factor: SFP (Small Form-factor Pluggable)
• Media type: Multimode fiber
• Typical reach: short-range multimode links (factory and cable-dependent)
• Interface: Duplex optical LC connector
• Hot-pluggable: Yes

How to use

Insert the SFP transceiver into an available SFP slot on a compatible switch, router or network interface card until it clicks into place. Connect duplex multimode fiber with LC connectors to the module, matching transmit and receive channels. Ensure correct fiber type and patch cable quality to achieve the specified short-range performance. After physical installation, verify link status through the host device management interface and monitor signal quality and speed to confirm proper operation.

Recommendations

Use multimode fiber rated for the intended link distance and maintain clean LC connector endfaces to prevent signal degradation. Match the transceiver wavelength and standard with connected equipment and observe manufacturer guidance on operating temperature and handling to ensure reliable, long-term performance.