SFP transceiver module BlueOptics SFP-10G-SR-WI-BO Copper 1000 Mbit/s

The BlueOptics SFP-10G-SR-WI-BO Copper 1000 Mbit/s is an SFP+ form-factor transceiver module designed for network equipment that accepts SFP+ interfaces. This compact, grey module supports a maximum data transfer rate of 1000 Mbit/s, weighs approximately 20 g, and is supplied as a single unit in the package. It is intended for high-speed data communication where an SFP+ copper transceiver is required and fits standard SFP+ slots for easy installation.

Advantages

The module’s SFP+ interface ensures mechanical and electrical compatibility with equipment that follows the SFP+ MSA form factor. Its lightweight construction and standard form factor allow fast, tool-free insertion and removal. Using a copper-based transceiver simplifies connections over short distances without the need for fiber cabling and reduces the number of different media types in mixed installations. The small size and low weight make it convenient for dense port deployments.

Suitable for

• Short-reach copper connections in switches and routers that accept SFP+ modules
• Server or storage interfaces requiring SFP+ copper transceivers
• Network lab testing and equipment replacement where SFP+ copper media is preferred

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 1000 Mbit/s
• Operating wavelength: 850 nm (module characteristic)
• Product colour: Grey
• Unit weight: ~0.02 kg
• Packaging: single-piece pack

How to use

Power down or follow hot-swap procedures recommended by your hardware vendor before inserting or removing the transceiver. Align the module with the SFP+ slot and push it in until it latches; to remove, release the latch and pull the module straight out. After installation, configure the host device’s port settings as required by your network (speed, duplex, or auto-negotiation) and verify link status through the management interface or indicator LEDs. Use appropriate copper patch cables and verify the supported cable length and connector type for reliable operation.

Recommendations

Ensure the host device supports SFP+ copper transceivers and the specified data rate. Store the module in an anti-static environment and avoid exposure to moisture and dust. For consistent operation, verify firmware and driver compatibility on the target hardware and perform link tests after installation.