Fiber Optic SFP Transceiver CBO M-SFP-LH+-LC-EEC 850 nm 10 km

CBO M-SFP-LH+-LC-EEC is a BlueOptics fiber optic SFP transceiver that operates at 850 nm and supports optical links up to 10 km. Designed for insertion into compatible SFP ports, this module uses a standard LC connector and is suitable for multimode or single-mode fiber systems as supported by the host device. The compact SFP form factor allows hot-swap installation and integration into switches, routers and other network equipment to provide short- to mid-range fiber connectivity.

Advantages

The transceiver delivers optical transmission at 850 nm with a rated reach up to 10 km, offering a balance between distance and compact SFP form factor. Its LC connector ensures compatibility with common fiber patch cables, while the hot-pluggable design enables tool-free replacement or upgrade without powering down the host system. Built to industry SFP specifications, the module supports straightforward integration into standard network ports and typical data center or campus fiber links.

Suitable for

• Fiber links between network switches in data centers and wiring closets
• Connecting routers and access devices over short- to mid-range fiber runs
• Upgrading SFP ports in managed switches to enable optical uplinks
• Redundant or spare modules for network maintenance and rapid replacement

Key specifications

• Optical wavelength: 850 nm
• Maximum reach: up to 10 km (system-dependent)
• Form factor: SFP (small form-factor pluggable)
• Connector type: LC duplex
• Fiber type: supports multimode and single-mode fiber as supported by host system
• Hot-pluggable: yes

How to use

Install the transceiver by inserting it into a compatible SFP slot on a switch, router or media converter until it clicks into place. Connect an LC duplex fiber patch cable between the transceiver and the remote device, observing correct transmit/receive orientation. Confirm link status via the host device interface and configure port speed or duplex settings if required by the network equipment. To remove, release the module latch and pull the SFP from the slot; cover unused transceiver ports and cable ends with dust caps to protect fiber interfaces.

Recommendations

Verify compatibility with the host device and fiber type before installation, and follow fiber handling best practices: avoid tight bends, keep connectors clean, and use appropriate dust caps when the module is not in use. Check link diagnostics on the network device after installation to confirm signal levels and operation.