Fiber optic SFP transceiver CBO GP-SFP2-1F 1.25Gbps 850nm multimode

CBO GP-SFP2-1F 1.25Gbps 850nm multimode is an SFP fiber optic transceiver designed for short-reach multimode fiber links. The module provides a hot-pluggable small form-factor pluggable (SFP) interface that supports 1.25 Gbps data rates over 850 nm wavelength. It is intended for use in network equipment such as switches, routers and media converters to enable optical uplinks, limit electromagnetic interference and extend cabling reach within local and campus networks.

Advantages

This SFP transceiver offers compact, hot-swappable installation and compatibility with standard SFP ports, allowing quick deployment and replacement without powering down equipment. Operating at 850 nm for multimode fiber, it supports common short-range Ethernet and fiber channel applications and provides a cost-effective option for upgrading copper links to optical connections. The module’s standardized form factor ensures broad interoperability with a variety of network devices and simplifies inventory management.

Suitable for

Key specifications

How to use

Install the transceiver by inserting the SFP module into an SFP slot on a compatible switch, router or media converter until it clicks into place. Connect an LC duplex multimode fiber cable to the transceiver’s optical port, observing correct transmit/receive orientation. Verify link status via the host device’s indicators or management interface and configure the port for appropriate speed and duplex settings if required. Remove the module by depressing the release latch and pulling it straight out; follow ESD precautions when handling the device and protect the optical ports with dust caps when not in use.

Recommendations

Use OM3/OM4 multimode fiber for optimal short-range performance and confirm that the host device supports 1.25 Gbps SFP optics. Maintain clean fiber connectors and use dust caps to prevent contamination. When troubleshooting link issues, check fiber polarity, connector cleanliness and device port configuration before replacing hardware.