CBO Transceiver SFP-1G-LH Fiber Optic 1G 1310nm

The CBO Transceiver SFP-1G-LH Fiber Optic 1G 1310nm is a small form-factor pluggable module that supports 1 Gbps data transmission over single-mode fiber at a wavelength of 1310 nm. Designed for long-reach connections, this SFP module is compatible with standard SFP ports on switches, routers and media converters, allowing network administrators to extend optical links and replace or upgrade existing 1G fiber modules while maintaining the standard SFP form factor and interface.

Advantages

This BlueOptics SFP-1G-LH transceiver provides a reliable 1G optical link for long-haul single-mode deployments. It offers plug-and-play compatibility with common SFP slots, predictable performance at 1310 nm wavelength, and a compact SFP form factor that minimizes space requirements in networking equipment. The module is suitable for straightforward replacement and network extension tasks without requiring changes to existing hardware architectures.

Suitable for

• Establishing 1 Gbps Ethernet links over single-mode fiber for campus and metro backbones
• Extending network reach between buildings or data centers where long-reach fiber links are needed
• Replacing or upgrading existing SFP modules in switches, routers, and media converters
• Use in network equipment with standard SFP ports that support 1G fiber transceivers

Key specifications

• Data rate: 1 Gbps
• Wavelength: 1310 nm
• Fiber type: single-mode fiber
• Form factor: SFP (small form-factor pluggable)
• Application: long-reach / long-haul optical links

How to use

Insert the CBO SFP-1G-LH module into a compatible SFP slot on a switch, router, or media converter until it clicks into place. Connect the single-mode fiber cable with matching LC connectors to the module’s optical interface, observing proper connector cleanliness and handling to avoid signal loss. Power on the network equipment and verify link status through device indicators or management interfaces; link negotiation should complete for 1 Gbps operation. When hot-swapping, follow the host equipment manufacturer’s procedures to avoid transient link disruption.

Recommendations

For consistent performance, use cleaned LC connectors and single-mode fiber cabling rated for long-reach applications. Verify that the host device accepts third-party SFP modules and that firmware/settings permit 1G optics. Monitor link status after installation and keep spare modules for rapid replacement in critical links.