AOC CBO QSFP-100G-AOC-10M 10m active optical cable for QSFP transceivers 100G length 10 m

AOC CBO QSFP-100G-AOC-10M is a factory-assembled 10 m active optical cable designed for QSFP-compatible 100G interconnects. This duplex optical assembly connects QSFP transceivers on switches, routers and servers, providing a single-cable solution for short-reach 100 Gigabit links. The cable is engineered to reduce electromagnetic interference and latency compared with copper alternatives while delivering consistent signal quality and simplified deployment in data center uplinks, aggregation layers and high-bandwidth server connections.

Advantages

The active optical cable offers predictable 100G performance over a fixed 10 m length with lower electrical interference and improved thermal behavior compared with direct-attach copper. Its QSFP-compatible form factor enables plug-and-play connection between QSFP ports without additional transceiver modules, reducing installation time and cable management complexity. The optical medium provides stable high-speed transmission, making it suitable for dense rack environments and multi-vendor network infrastructures where consistent signal integrity is required.

Suitable for

• Data center switch-to-switch uplinks at 100G
• Aggregation and spine-leaf connections inside racks
• High-performance server connections and NIC-to-switch links
• Short-reach interconnects where low latency and EMI immunity are important

Key specifications

• Nominal data rate: 100 Gigabit duplex
• Connector form factor: QSFP-compatible plug ends
• Cable type: Active optical cable with integrated transceivers
• Length: 10 metres
• Transmission medium: multimode optical fibers inside a duplex assembly
• Typical use environment: data center and enterprise network racks
• Electrical characteristics: optical signalling to minimise electromagnetic interference

How to use

Install the AOC by plugging each QSFP-compatible end into the corresponding QSFP port on networking equipment. Verify that connected devices support 100G QSFP-AOC links and that ports are configured for the intended link aggregation or lane mode. No separate transceivers or patch cords are required; handle the cable by the connector housings and avoid sharp bends near the plugs. After insertion, confirm link status on the devices and monitor for expected link speed and error counts during initial operation.

Recommendations

For reliable operation, route the cable to avoid tight bend radii and heavy compression; maintain manufacturer-recommended minimum bend radius for optical assemblies. Use this AOC in cooled rack environments and ensure QSFP ports are compatible with active optical cable assemblies. When replacing or re-routing, power down or disable the port if required by your equipment's hot-swap procedures and inspect connector interfaces for dust or damage before insertion.