AOC CBO QSFP-100G-AOC-5M active optical cable, 100G, QSFP+ to QSFP+, 5 m

AOC CBO QSFP-100G-AOC-5M is a 5-meter active optical cable engineered for 100G links using QSFP+ form-factor connectors. The cable provides a direct, low-latency connection between compatible QSFP ports on switches, routers or servers, intended for short-reach interconnects in data center and high-performance networking environments. It integrates optical transceivers and a pre-terminated fiber link into a single assembly to simplify installation and reduce the power and complexity associated with discrete transceivers and separate fiber patching.

Advantages

This active optical cable delivers a compact, factory-terminated solution that reduces installation time and avoids manual fiber termination. The integrated design lowers overall power consumption compared with separate transceivers and patch cords, while offering predictable signal performance and reduced electromagnetic interference. Its 5 m length supports flexible rack-to-rack or within-rack connections while maintaining the signal integrity required for 100G traffic.

Suitable for

• Short-reach data center interconnects between switches and routers
• High-bandwidth uplinks and server-to-switch connections
• Leaf-spine network fabrics and aggregation links
• Environments requiring low-latency, high-throughput links

Key specifications

• Data rate: 100 Gbps aggregate
• Connector type: QSFP+ to QSFP+
• Cable type: Active optical cable (AOC) with integrated transceivers
• Length: 5 meters
• Typical applications: short-reach interconnects in data centers and enterprise networks

How to use

Install the AOC by inserting each QSFP+ connector into the corresponding QSFP port on the networking devices until the module latches. No separate transceivers, fibers, or patch panels are required. Verify that connected devices support QSFP+ AOC connections and 100G link negotiation; configure port settings on switches or servers as needed. For safe handling, avoid sharp bends in the cable and maintain recommended bend radii to preserve optical performance.

Recommendations

Use this 5 m active optical cable for direct connections within racks or between adjacent racks where a factory-terminated, low-power 100G link is preferred. Ensure both endpoints support QSFP+ AOC modules and check device firmware or compatibility lists if necessary. Store and route the cable to avoid excessive bending, pulling, or exposure to mechanical stress that could degrade performance.