Adapter ShiverPeaks 94001 — SCART to RCA video/audio adapter

ShiverPeaks 94001 is a SCART to RCA video/audio adapter that converts a SCART output to composite video and stereo RCA audio signals. It enables connection of SCART-equipped sources — such as older VCRs, DVD players or gaming consoles — to displays and audio equipment with RCA composite video and left/right audio inputs. The adapter provides the physical interface necessary to pass composite video signal and two-channel analogue audio without signal processing.

Advantages

The adapter offers a compact, passive conversion from SCART to RCA connectors, requiring no external power or drivers. Its simple form factor allows quick plug-and-play setup and preserves the original composite video and stereo audio wiring. The device is suitable where a direct physical connection is needed between legacy SCART devices and modern RCA-equipped TVs, monitors or AV receivers.

Suitable for

• Connecting SCART-equipped VCRs to TVs with RCA composite inputs
• Hooking up DVD players or retro game consoles to RCA-based displays
• Routing analogue audio (left/right) from SCART sources to AV receivers
• Temporary connections in test, repair or refurbishment of legacy AV equipment

Key specifications

• Connector type: SCART (input) to RCA composite video and stereo RCA audio (outputs)
• Signal supported: Composite video (analog) and two-channel analogue audio (L/R)
• Power requirements: passive (no external power required)
• Compatibility: designed for SCART devices that output composite video and analog audio
• Form factor: compact inline adapter for direct cable connection

How to use

Insert the SCART end of the adapter into the SCART socket of the source device until it sits firmly. Connect the composite video RCA plug (usually yellow) to the composite video input on the target display, and connect the left and right audio RCA plugs (usually white and red) to the corresponding audio inputs. Set the display or receiver input to the connected RCA channel. No configuration or power source is required; if no picture or sound is present, verify the source device is outputting composite and the cables are seated correctly.

Recommendations

For reliable signal transfer, use short, good-quality RCA cables and confirm the source is set to composite output mode. Avoid routing cables near strong electrical interference to reduce noise in the analogue audio and video signals. If a device uses RGB over SCART rather than composite, verify composite output is available or use an appropriate converter that supports RGB-to-composite conversion.