ACT Yellow 10 meter U/UTP CAT6A patch cable with RJ45 connectors

The ACT Yellow 10m U/UTP CAT6A RJ45 patch cable is a 10‑metre network cable with full copper conductors and gold‑plated RJ45 connectors. It meets ANSI/TIA568‑C2‑1 performance requirements and is compatible with CPR Euroclass Eca. The cable is U/UTP (unshielded twisted pair with overall braid absence) and supports 10/100/1000Base‑T(X) data rates, making it suitable for high‑speed Ethernet links in home and office networks.

Advantages

This patch cable uses full copper conductors to ensure optimal electrical conductivity and reliable Power over Ethernet (PoE) performance. Gold‑plated RJ45 connectors provide stable, low‑resistance contacts and reduce corrosion. Compliance with ANSI/TIA standards and CPR Euroclass Eca gives predictable performance and safety classification for structured copper cabling installations.

Suitable for

• Connecting switches, routers, patch panels and network devices in office or home environments
• High‑speed Ethernet links up to Gigabit speeds (10/100/1000Base‑T(X))
• Power over Ethernet (PoE) enabled devices such as IP phones and access points

Key specifications

• Length: 10 m
• Standard: U/UTP CAT6A
• Connectors: RJ‑45 to RJ‑45, gold plated
• Conductors: full copper
• Supported cabling technology: 10/100/1000Base‑T(X)
• Colour: Yellow
• CPR Euroclass: Eca

How to use

Plug one RJ45 connector into the network port of your switch, router, patch panel or device and plug the other end into the corresponding port. Avoid excessive bending or tension on the cable; maintain a bend radius greater than the cable diameter and route the cable away from high‑power electrical lines to minimise interference.

Recommendations

For reliable PoE operation and long service life, use ACT patch cables with full copper conductors and ensure connectors are fully seated. Replace cables that show visible damage or degraded connector contacts.