XLR cable PSSO 3-pin, balanced audio cable, 5 m, Neutrik connectors

PSSO 3-pin XLR cable with Neutrik connectors, 5 m long, is a balanced audio cable designed for professional audio signal transmission. It connects microphones, mixing consoles and other balanced equipment, providing consistent signal integrity over a standard 5‑metre length. The cable is intended for use in stage, studio and live sound environments where a durable, industry‑standard XLR connection is required.

Advantages

This balanced XLR cable uses three conductors to maintain low noise and reduced electromagnetic interference, while Neutrik connectors ensure secure mating, low contact resistance and repeatable connections. The 5 m length offers flexibility without excessive signal loss for typical stage and studio distances, and the cable construction provides mechanical durability for frequent handling and setup.

Suitable for

Key specifications

How to use

Connect the female XLR end to the microphone or source device and the male XLR end to the mixing desk, preamp or destination input. Ensure connectors are fully seated until the latch clicks to prevent intermittent connections. Route the cable away from power cables and high‑current equipment to minimize potential interference; use cable wraps or ties for neat runs and reduced tripping hazards. For condenser microphones requiring phantom power, confirm that the connected preamp or mixer supplies the correct phantom voltage before use.

Recommendations

Inspect connectors periodically for loose pins or dirt and avoid sharp bends near the connector boots. Coil the cable using the over‑under method for storage to maintain cable life and prevent tangles. For permanent installations or outdoor use, choose routing and protection that prevent moisture exposure and mechanical strain.