UTP Cat5e networking cable LOGON 15 m, RJ-45 to RJ-45, blue

LOGON UTP Cat5e networking cable, 15 m in length, provides a reliable connection for Ethernet networks and local area wiring. This unshielded twisted pair cable meets Cat5e specifications and is equipped with RJ-45 male connectors on both ends. The blue jacket makes it easy to identify in structured cabling environments while the built-in boot with kink protection and strain relief helps maintain connector integrity during installation and everyday use.

Advantages

The LOGON Cat5e cable supports standard Cat5e performance for data and voice transmission over short to medium distances and offers a 100 Ω impedance through four pairs of 26/7 AWG conductors. Its UTP construction simplifies installation where shielding is not required, and the molded boots with strain relief reduce bent-pair stress at the connectors. The 15 m length allows flexible placement of network devices without needing additional patch panels or extenders.

Suitable for

• Connecting computers, printers and IP devices to routers or switches
• Patching between wall sockets and network equipment in offices and homes
• Temporary or permanent LAN setups where Cat5e performance is sufficient
• Voice over IP (VoIP) phones and home network cabling

Key specifications

• Length: 15 m
• Cable type: UTP (Unshielded Twisted Pair)
• Category: Cat5e
• Conductor: 4 pairs, AWG 26/7
• Characteristic impedance: 100 Ω
• Connectors: RJ-45 male to RJ-45 male
• Color: Blue
• Molded boot with kink protection and strain relief

How to use

Plug each RJ-45 connector into the corresponding Ethernet ports of the devices you wish to connect, ensuring correct seating until the locking tab clicks. Route the cable to avoid sharp bends and excessive tension; use the molded boot to guide the cable at the connector and avoid kinking. For wall-mounted installations, allow slack and use cable clips or ties to secure the run without compressing the jacket or deforming the pairs.

Recommendations

Use the LOGON Cat5e cable for standard 10/100/1000 Mbps Ethernet connections where Cat5e specifications meet performance needs. Avoid running the cable in parallel with high-voltage power lines to minimize interference, and replace the cable if connectors or jacket show visible damage. For environments requiring shielding or higher bandwidth, consider Cat6 or shielded alternatives.