Ubiquiti UACC-OM-SFP10-1290 network transceiver module 11300 Mbit/s SFP+ 1290 nm

The Ubiquiti UACC-OM-SFP10-1290 is an SFP+ CWDM fiber optic transceiver module that supports 10G connections over single-mode fiber. It operates at a center wavelength of 1290 nm, provides a maximum data transfer rate of 11,300 Mbit/s, and connects using a duplex LC UPC connector. The compact module is compatible with equipment that accepts SFP+ form-factor transceivers and is intended for CWDM links up to 20 km.

Advantages

This Ubiquiti transceiver provides high-speed 10G capability in an SFP+ form factor, supports CWDM operation to increase wavelength-density on single-mode fiber, and uses a standard duplex LC UPC connector for broad compatibility. The module’s specified reach of up to 20 km allows use in longer-distance single-mode links while maintaining a compact, hot-pluggable design.

Suitable for

• 10G Ethernet links over single-mode fiber
• CWDM wavelength multiplexing deployments
• Data center uplinks and aggregation
• ISP and enterprise point-to-point fiber connections up to 20 km

Key specifications

• Brand: UBIQUITI
• Model / MPN: UACC-OM-SFP10-1290
• Form factor: SFP+
• Wavelength: 1290 nm (CWDM)
• Maximum data transfer rate: 11,300 Mbit/s
• Connector: Duplex LC UPC
• Fiber type: Single-mode fiber
• Maximum reach: up to 20 km
• Product colours: Grey, Yellow

How to use

Insert the SFP+ module into a compatible SFP+ slot on your network device while the device is powered according to the equipment manufacturer’s instructions. Connect single-mode duplex LC fiber patch cables to the module’s LC UPC ports, ensuring correct transmit/receive orientation. Configure the connected network ports in your switch, router, or transceiver host to enable 10G operation and any required CWDM wavelength settings or link parameters.

Recommendations

Use single-mode duplex LC UPC patch cables and verify link budget for runs approaching 20 km. Confirm compatibility with your network equipment and firmware, and handle the module and fiber connectors with appropriate ESD precautions and dust caps when not in use.