SFP+ transceiver module BlueOptics USFP+-192/S1/SW-BO 10000 Mbit/s 1310 nm

The BlueOptics USFP+-192/S1/SW-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s class networks. It operates at a wavelength of 1310 nm and supports single‑mode fiber links. The module has a compact form factor, weighs approximately 20 g and uses an SFP+ interface with LC duplex connectivity, making it suitable for installation in compatible switches, routers and storage systems that accept SFP+ modules.

Advantages

This transceiver supports high data rates up to 10000 Mbit/s while maintaining a small, industry-standard SFP+ footprint for straightforward hot-plug installation. Its silver housing and lightweight design allow easy handling and reduced rack weight. By operating on the 1310 nm window over single‑mode fiber, it enables longer distance links compared with typical multimode modules. The module is manufactured to MSA-compatible mechanical and electrical standards to ensure interoperability with a wide range of network equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics USFP+-192/S1/SW-BO into an empty SFP+ port of a compatible device until it clicks into place. Connect LC duplex single‑mode fiber patch cords with correct polarity to the module’s connector. Ensure the host device is configured for the intended 10G Ethernet or protocol and that link partners are set to compatible speeds. Use the host device’s interface status indicators or management interface to verify the optical link and link speed after installation.

Recommendations

Confirm that the target switch, router or storage system supports SFP+ modules and the 1310 nm single‑mode transceiver type before installation. Use quality single‑mode LC duplex patch cords and keep connectors clean to maintain signal quality. If available, enable digital diagnostic monitoring on the host device to monitor optical parameters and support remote troubleshooting.