SFP transceiver module BlueOptics TN-SFP-10/25G-LR-S-BO 10000 Mbit/s QSFP28

The BlueOptics TN-SFP-10/25G-LR-S-BO is a fiber-optic SFP transceiver module designed for high-speed single-mode links. It supports up to 10000 Mbit/s transfer rate, operates at a wavelength of 1310 nm and uses a QSFP28-compatible interface with an LC duplex connector. The module is compact and lightweight (approximately 2 g) and requires a 3.3 V input, making it suitable for installation in compatible network equipment to extend or replace optical uplinks.

Advantages

This BlueOptics SFP transceiver is manufactured to MSA standards to ensure physical and electrical compatibility with equipment that supports the original module. It supports both transmit and receive operation at 1310 nm over single-mode fiber and includes digital diagnostics monitoring (DDM/DOM) for remote measurement of supply voltage, laser bias current, transmit power, receive power and temperature when the host hardware supports the feature. The module’s small form factor, low weight and industry-standard optical connector enable straightforward installation and compact deployment in switches, routers and other network platforms.

Suitable for

Key specifications

How to use

Install the transceiver into an empty compatible QSFP28/SFP28 port on a switch, router or other host device following the host manufacturer’s hot-swap and handling instructions. Connect single-mode LC duplex patch cords to the module’s optical ports, ensuring correct transmit/receive orientation. Verify link establishment and speed through the host device management interface. If supported by the host, enable and monitor DDM/DOM parameters for real-time diagnostics and link health information.

Recommendations

Ensure the host equipment officially supports the corresponding form factor and data rate. Use certified single-mode fiber patch cords and, where possible, test the module in your environment before large-scale deployment. Observe electrostatic discharge (ESD) precautions during handling and avoid contaminating the LC connector endfaces; clean connectors as needed to maintain optimal optical performance.