SFP transceiver module BlueOptics SFPLX-WB-BO 1250 Mbit/s 1310 nm

The BlueOptics SFPLX-WB-BO 1250 Mbit/s 1310 nm is a small-form-factor pluggable (SFP) fiber optic transceiver designed for single-mode fiber links. It supports data transfer rates up to 1250 Mbit/s at a center wavelength of 1310 nm and uses an LC duplex connector. The module's compact SFP form factor and light weight make it suitable for installation in switches, routers and other networking equipment that accept standard SFP transceivers, providing reliable optical transmission over distances up to 10 km.

Advantages

The BlueOptics SFP offers a standard-compliant 1000BASE-LX interface with LC duplex termination for simultaneous transmit and receive channels. Its single-mode 1310 nm optics enable long-reach links while remaining less susceptible to electromagnetic interference compared with copper connections. The module is manufactured to MSA-compatible mechanical specifications and is tested for interoperability with common networking platforms. Its small size, low weight and plug-and-play SFP form factor simplify deployment and replacement in rack-mounted equipment.

Suitable for

Key specifications

How to use

Install the module into an SFP slot of a compatible network device while the device is powered down or following the manufacturer's hot-swap procedure. Connect an LC duplex single-mode fiber patch cable with the correct polarity to the transmit and receive ports. Configure the host device for the intended interface and verify link status. If the device supports digital diagnostics (DDM/DOM), monitor optical parameters such as Tx/Rx power and temperature through the management interface to confirm proper operation.

Recommendations

Use single-mode LC patch cables rated for 1310 nm and minimize tight bends or excessive pulling on fiber cables. Verify hardware compatibility and, where available, enable DDM/DOM monitoring for proactive diagnostics. Store and handle the transceiver in anti-static conditions and follow manufacturer guidance for insertion and removal to avoid port damage.