SFP transceiver module BlueOptics SFP28-25G-ERL-30-CN-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-CN-BO is a fiber optic SFP28 transceiver module engineered for 25 Gbit/s single-lane links. It provides a compact hot-pluggable form factor compatible with SFP28 ports and is intended for deployment in data centers, aggregation switches and enterprise access equipment where high-speed optical connections over longer distances are required.

Advantages

This SFP28 module supports a 25000 Mbit/s data rate and offers a standardized SFP28 interface for interoperability with modern network hardware. Its fiber optic design enables low-latency, high-bandwidth transmission and electrical isolation between devices. The compact SFP form factor simplifies upgrades and maintenance by allowing hot-swap replacement without powering down the host system.

Suitable for

• 25G Ethernet uplinks and aggregation links in data centers
• High-speed fiber connections between switches and routers
• Enterprise networks requiring low-latency optical links
• Network equipment upgrades to SFP28-capable ports

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25000 Mbit/s
• Form factor: Hot-pluggable SFP28 module
• Transmission medium: Single-mode/multimode fiber (fiber type depends on module variant and link design)
• Typical applications: 25G Ethernet links, data center interconnects

How to use

Install the BlueOptics SFP28-25G-ERL-30-CN-BO by inserting the module into an SFP28-compliant port until it clicks into place. Connect the appropriate fiber optic cable and secure any protective dust caps on unused ports. Configure the host switch or router to recognize the 25G link and verify link status and speed through the device management interface. For removal, unlock the module per the host device procedure and pull it straight out while the system is online if hot-swap support is available.

Recommendations

Use factory-certified or equivalent quality fiber cables and follow transceiver vendor specifications for power budget and link distance. Verify compatibility with the host device firmware and supported SFP28 modules. Handle the optical interfaces with care to avoid contamination and always replace dust caps when connectors are not in use.