SFP transceiver module BlueOptics 6GK60008FE500AA0 155 Mbit/s 1310 nm

The BlueOptics 6GK60008FE500AA0 155 Mbit/s 1310 nm SFP transceiver module is a compact fiber optic device designed for serial data transmission over single-mode fiber. Supporting a maximum data rate of 155 Mbit/s and operating at a wavelength of 1310 nm, this SFP form-factor module connects network equipment via a standardized interface and is intended for telecommunication and data communications links where moderate bandwidth and reliable optical link performance are required.

Advantages

This SFP transceiver offers a standardized SFP interface for hot-swappable installation, reducing downtime during upgrades or replacement. Its operation at 1310 nm provides good performance for intermediate-range single-mode fiber links, while the 155 Mbit/s data rate matches common synchronous and legacy transmission systems. The compact SFP package enables flexible deployment in switches, routers, media converters and other compatible networking devices.

Suitable for

• Telecommunication links and access networks using single-mode fiber
• Synchronous transport or legacy SDH/SONET applications requiring 155 Mbit/s
• Edge switches, routers and media converters with SFP ports
• Point-to-point optical connections for moderate distances

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF) compatibility
• Interface: electrical SFP host connector for hot-pluggable operation

How to use

Install the module into a compatible SFP slot on the network device while the host is powered down or with hot-swap procedures supported by the equipment. Connect the single-mode fiber cable with the correct connector type to the transceiver’s optical port, ensuring proper fiber orientation and cleanliness of endfaces. Configure the host device for the required link parameters and verify the optical link status through device diagnostics. Replace or reseat the module using safe handling practices to avoid static discharge and contamination of the optical interfaces.

Recommendations

Use single-mode fiber with appropriate attenuation and connector types for 1310 nm operation, keep fiber endfaces clean, and verify compatibility with your network equipment’s SFP implementation. Monitor link status after installation and keep spare modules on hand for quick replacement in critical links.