SFP transceiver module BlueOptics 1241510000-BO 1250 Mbit/s Fiber optic

The BlueOptics 1241510000-BO SFP transceiver module is a compact fiber optic network module engineered for single-port uplinks and short- to medium-range fiber links. It supports a maximum data transfer rate of 1250 Mbit/s and is built in the standard SFP form factor to fit a wide range of switches, routers and media converters. The module uses an LC (UPC) fiber connector and is supplied in a silver housing with a lightweight construction of approximately 20 g. With a rated mean time between failures (MTBF) of 1,000,000 hours, it is intended for reliable operation in Ethernet networking environments.

Advantages

The SFP transceiver offers straightforward integration into existing SFP ports thanks to its standard form factor and LC (UPC) connector. Its 1250 Mbit/s transfer capability supports typical SFP Ethernet links while the 10,000 m maximum transfer distance enables use in campus and building-to-building connections. The low weight and compact size simplify installation in dense port environments, and the high MTBF indicates long-term operational stability.

Suitable for

• Fiber uplinks between switches and media converters
• Campus and metropolitan area connections up to 10 km
• Replacing or upgrading SFP ports in networking equipment
• Single-mode fiber links using LC (UPC) connectors

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 10,000 m (single-mode fiber)
• Ethernet interface type: 1.25 Gigabit Ethernet (SFP)
• Fiber optic connector type: LC (UPC)
• Housing colour: Silver
• Weight: approx. 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Power down the host device or follow hot-swap procedures supported by your switch or router, then insert the SFP transceiver into an available SFP port until it clicks into place. Connect a compatible LC-terminated single-mode fiber cable (UPC polish) and verify link status via the host device LEDs or management interface. Configure interface parameters on the switch or router as required for your network (speed, duplex, and any VLAN or interface settings). When removing the module, disconnect the fiber cable first and then press the eject mechanism or release tab to withdraw the transceiver.

Recommendations

Use single-mode fiber cabling with LC (UPC) connectors and maintain proper end-face cleaning to ensure signal quality. Verify compatibility with the host equipment's supported SFP modules before installation, and avoid exposing the module to excessive mechanical stress or moisture during handling and operation.