SFP transceiver module BlueOptics 10059 Fiber optic 1250 Mbit/s

The BlueOptics 10059 Fiber optic SFP transceiver module is designed for reliable optical data transmission in networking equipment that accepts SFP interfaces. Supporting a maximum data transfer rate of 1250 Mbit/s, this compact module enables single-channel fiber connections for links where SFP form-factor compatibility is required. The module is intended to integrate with switches, routers and media converters that support hot-pluggable SFP modules and provide an optical interface for short- to medium-range fiber communication.

Advantages

The SFP form factor provides flexibility and hot-pluggable convenience, allowing equipment to be upgraded or serviced without powering down. With an optical interface and a rated data transfer speed of 1250 Mbit/s, the module supports standard fiber networking applications while maintaining low power consumption and compact dimensions suitable for densely populated chassis. The BlueOptics 10059 is compatible with common SFP ports and follows standard electrical and mechanical SFP specifications to facilitate straightforward replacement or expansion of optical links.

Suitable for

• Connecting switches and routers via single-channel fiber links
• Media converters and network appliances requiring SFP optical modules
• Upgrading copper-based links to fiber in local networks
• Temporary or permanent deployment in enterprise and ISP access networks

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Transmission medium: fiber optic
• Form factor: hot-pluggable SFP module
• Typical application: single-channel optical links for networking equipment

How to use

Insert the BlueOptics 10059 SFP transceiver into an empty SFP slot on compatible switches, routers or media converters until it latches securely. Connect a compatible fiber optic cable to the module’s optical port, ensuring correct fiber type and connector orientation. After physical installation, verify link status in the host device’s management interface and configure port settings as required for your network (speed, duplex, auto-negotiation or SFP-specific configuration). Follow your equipment vendor guidelines for safe handling to avoid contamination of optical interfaces.

Recommendations

Handle the optical connector ends with care and keep protective caps on connectors when not in use; clean connectors before mating to reduce signal loss. Confirm compatibility of the SFP slot and fiber type (single-mode or multimode) with the BlueOptics 10059 and follow your system vendor’s supported transceiver list for best interoperability.