SFP transceiver module BlueOptics 10-2354-01 1250 Mbit/s 1550 nm

The BlueOptics 10-2354-01 1250 Mbit/s 1550 nm SFP transceiver module is a compact fiber optic interface designed for single-port fiber links and small form-factor network equipment. It supports a data transfer rate of 1250 Mbit/s and operates at a wavelength of 1550 nm, enabling reliable optical communication over fiber infrastructure. The module fits SFP slots and is intended to extend fiber connections or replace existing transceivers in switches, routers and media converters that accept SFP form factors.

Advantages

This SFP transceiver provides a standard SFP interface and a stable maximum data rate of 1250 Mbit/s, ensuring compatibility with equipment that follows SFP specifications. The 1550 nm operating wavelength is suitable for longer-reach single-mode fiber links, offering low attenuation and consistent optical performance. Its compact SFP form factor simplifies installation and replacement in compatible network devices without requiring changes to existing hardware racks or fiber cabling.

Suitable for

• Single-mode fiber links requiring 1250 Mbit/s serial data transmission
• Network switches, routers and media converters with SFP ports
• Extending or restoring optical links in enterprise or carrier networks
• Backup or spare transceiver inventory for maintenance operations

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Operating wavelength: 1550 nm

How to use

Before installation, verify that the host device supports SFP modules and that the optical fiber type and connectors are compatible with a 1550 nm transceiver. Power down the equipment if recommended by the device manufacturer. Insert the BlueOptics SFP module into an empty SFP port until it seats firmly and lock any retention mechanism. Connect the appropriate single-mode fiber cable to the transceiver's optical connector, observing correct polarity. Power on the device and check link LEDs or management interfaces to confirm the optical link is established and operating at the expected rate.

Recommendations

Store and handle the transceiver in an electrostatic-safe environment and keep protective caps on optical connectors when not in use. Use single-mode fiber rated for 1550 nm and ensure connector endfaces are clean to maintain link quality. Consult the host device documentation for supported SFP modules and any required firmware settings for optical port configuration.