SFP transceiver BlueOptics FL SFP WDM10-A-BO 10000 Mbit/s 1310 nm

The BlueOptics FL SFP WDM10-A-BO 10000 Mbit/s 1310 nm is a compact fiber optic SFP transceiver module designed for single-mode fiber links. Supporting a maximum data transfer rate of 10 Gbit/s and transmitting at a wavelength of 1310 nm, this silver-coloured module provides a standardized interface for insertion into SFP ports on switches, routers and media converters. The module is intended to carry high-speed network traffic over fiber while maintaining compatibility with common SFP-equipped networking equipment.

Advantages

The transceiver offers a standardized SFP interface for easy hot-swap installation and network upgrades without powering down equipment. With support for 10000 Mbit/s throughput at 1310 nm, it is suitable for long-distance single-mode fiber transmission where a reliable signal and low latency are required. Its compact silver housing ensures a small form factor that fits into standard SFP slots and helps maintain consistent mechanical and optical alignment.

Suitable for

Key specifications

How to use

Insert the BlueOptics FL SFP WDM10-A-BO into a compatible SFP slot on your network device while the device is powered according to the vendor's hot-swap guidelines. Connect the single-mode fiber cable using the appropriate connector type for your installation, ensuring clean end-faces and correct polarity. Verify link status on the host device and configure interface settings such as speed and duplex if required by the device. Follow network equipment vendor instructions for firmware or compatibility limitations.

Recommendations

Use cleaned and tested single-mode fiber cables for best optical performance, avoid bending cables beyond manufacturer bend-radius limits, and confirm compatibility with the host device’s SFP specifications before deployment. Observe ESD precautions when handling the transceiver and keep protective dust caps on connectors when not in use.