QSFP Transceiver BlueOptics QSFP-100G-DR-JU-BO 100G LC Silver

The BlueOptics QSFP-100G-DR-JU-BO 100G LC Silver is a QSFP28 fiber optic transceiver module designed for 100G data transmission over single-mode fiber. It uses an LC duplex interface in a compact QSFP28 form factor, housed in a durable metal enclosure and weighing approximately 40 g. The module supports up to 100 Gbit/s line rate and is specified for optical link distances up to 500 m, making it suitable for high-density data center and enterprise networking environments that require 100GBASE-DR connectivity and compatibility with Juniper platforms that accept the original QSFP-100G-DR-JU module.

Advantages

This transceiver complies with MSA QSFP28 mechanical and optical specifications and provides Digital Diagnostics Monitoring (DDM/DOM) for real-time monitoring of supply voltage, laser bias current, transmit power, receive power and temperature where supported by the host hardware. The module is built with a metal housing for mechanical robustness, supports LC duplex connections for simultaneous transmit and receive on separate fibers, and is produced using industry-standard optical components to achieve long operational lifetime and stable performance in 100G networks.

Suitable for

Key specifications

How to use

Install the QSFP-100G-DR-JU-BO module into a compatible QSFP28 slot on a switch, router, or other network device while the host device is powered according to the manufacturer’s installation guidelines. Connect LC duplex single-mode fiberpatch cords to the transceiver’s LC interface, ensuring correct orientation for transmit and receive fibers. Verify link establishment and monitor module parameters using the host system’s management interface or DDM/DOM telemetry if available. Follow the network equipment vendor’s instructions for hot-plug handling, firmware compatibility and any vendor-specific enablement steps required for third-party transceivers.

Recommendations

To achieve optimal link performance and lifetime, use single-mode LC patch cords rated for 100GBASE-DR distances, avoid tight bends or stress on fiber connectors, and confirm that the target hardware supports third-party QSFP-100G-DR compatible transceivers and DDM/DOM monitoring. For initial deployment, test one module in the intended host to confirm compatibility and functionality before large-scale rollout.