Network transceiver module BlueOptics JL274A-BO 100 Mbit/s QSFP28

The BlueOptics JL274A-BO 100 Mbit/s QSFP28 network transceiver module is a compact optical interface designed for fiber-based networking environments. It implements a QSFP28 form factor with an MPO/MTP fiber connector and supports a maximum data transfer rate of 100 Mbit/s. The module is lightweight (40 g) and comes in grey, intended for integration into network switches, routers and other compatible hardware that accept QSFP28 optical modules.

Advantages

This QSFP28 transceiver provides a standardized MPO/MTP connector and a compact QSFP28 interface that simplifies installation in systems with compatible ports. The small form factor and low weight make it easy to handle and install in dense switch environments. The module is manufactured to industry interoperability standards, allowing straightforward replacement or expansion of existing fiber links while maintaining consistent optical connection characteristics.

Suitable for

• Connecting fiber-optic links in data center switches and aggregation switches
• High-density fiber ports where QSFP28 mechanical form factor is required
• Short-range multimode fiber links using MPO/MTP connectivity
• Upgrading or replacing compatible QSFP28 transceivers in network hardware

Key specifications

• Interface type: QSFP28
• Maximum data transfer rate: 100 Mbit/s
• Connector type: MPO/MTP fiber connector
• Form factor: QSFP28 optical transceiver module
• Typical application: multimode fiber optical links
• Weight: 0.04 kg (40 g)
• Colour: Grey

How to use

Install the BlueOptics JL274A-BO module into a compatible QSFP28 port on the target network device while the device is powered down or following the device vendor's hot-swap procedure. Connect an MPO/MTP multimode fiber patch cord to the module's connector and route the fiber to the corresponding transceiver or patch panel. Verify physical link and port status through the host device management interface and perform any required configuration for the intended protocol and network segmentation.

Recommendations

Ensure the host device supports QSFP28 transceivers and the intended link rate. Use appropriate multimode MPO/MTP fiber and maintain clean fiber endfaces to avoid insertion loss. Confirm optical reach and link budget match the network topology; for monitoring, enable any available diagnostic features in the host hardware to observe optical parameters and temperature if supported.