Network patch cable LANBERG Cat6 U/UTP 0.25 m RJ-45 to RJ-45 blue

LANBERG Cat6 U/UTP patch cable, 0.25 m, with RJ-45 connectors at both ends and a blue PVC jacket. Designed for short Ethernet connections in patch panels, switches, routers and desktop setups, this Cat6 cable supports frequencies up to 250 MHz and a data rate up to 10 000 Mbit/s. The cable uses 26 AWG 7×0.16 mm conductors made of CCA and an outer diameter of approximately 5.4 mm, providing a compact connection where space in racks or behind equipment is limited.

Advantages

The cable complies with ANSI/TIA/EIA-568-B recommendations and ISO/IEC 11801 class D requirements for Category 6 performance, ensuring predictable signal transmission for short links. Its U/UTP construction (unshielded overall with unshielded pairs) and PVC jacket deliver a flexible, easy-to-route cable for dense installations. With standard RJ-45 male connectors on both ends and a 0.25 m length, it is suitable for minimizing excess cable in server racks and between adjacent devices.

Suitable for

Key specifications

How to use

Connect one RJ-45 plug to the network device and the other to the corresponding port on the switch, patch panel or router. Ensure connectors are fully seated and the latch clicks into place. Use the 0.25 m cable to replace or shorten existing patching where a compact, low-slack connection is needed. Observe proper cable routing to avoid sharp bends and maintain bend radius consistent with the cable outer diameter.

Recommendations

For optimal performance keep the cable length appropriate to the link requirements; this 0.25 m patch cable is intended for short links only. Avoid running unshielded cables in close parallel with high-voltage power lines to reduce potential interference. Where higher electromagnetic immunity is required, consider shielded cabling solutions. Inspect connectors for damage before installation and avoid excessive pulling force on the jacket during routing.