Network cable LOGON TCF66F250R Cat6a F/UTP (FTP) Red, 25 m, RJ-45–RJ-45

LOGON TCF66F250R is a 25 m Cat6a F/UTP (FTP) network patch cable with shielded RJ-45 connectors on both ends. Designed for 10 Gigabit Ethernet and high-speed LAN links, this red cable uses foil shielding and individually twisted pairs to reduce electromagnetic interference and maintain stable transmission over longer distances. The cable follows EIA/TIA 568 wiring standards and is suitable for structured cabling, office racks and data center patching where shielded Cat6a performance is required.

Advantages

The foil-shielded F/UTP construction provides improved protection against external EMI compared with unshielded cables, supporting reliable high-speed data transfer. Built with 4 x 2 AWG 26/7 twisted pairs and a 100 ohm characteristic impedance, it meets Cat6a performance parameters for reduced crosstalk and consistent signal integrity. Shielded RJ-45 connectors and a PVC sheath ensure straightforward plug-and-play installation while offering mechanical protection and a visible color for cable management.

Suitable for

• 10 Gigabit Ethernet connections in LAN environments
• Structured cabling in offices and commercial buildings
• Patch panels and server rack connections in data centers
• Shielded network links where EMI protection is needed
• Longer horizontal runs up to the cable's length limit

Key specifications

• Category: Cat6a (augmented Category 6)
• Shielding: F/UTP (foil screened overall with unshielded pairs)
• Conductor: 4 pairs, 26 AWG (7-strand)
• Characteristic impedance: 100 ohm
• Connectors: Shielded RJ-45 male on both ends
• Length: 25 m
• Outer sheath: PVC
• Color: Red
• Standards: EIA/TIA 568 compliant
• Installation: Plug and play

How to use

Connect one shielded RJ-45 end to the network interface of a switch, router or patch panel and the other end to the target device or port. Ensure both connecting devices support the required network speed and that grounding practices for shielded cabling are followed within the installation to maximize EMI protection. Avoid sharp bends and excessive pulling force during routing to preserve cable performance.

Recommendations

For optimal performance, maintain proper bend radius and avoid running the cable in parallel with high-voltage power lines. When integrating into a shielded installation, bond the cable shields to the system ground at appropriate grounding points. Use the red color for visible identification in structured cabling systems and replace cables that show mechanical damage or connector wear.