Lighting DMX Pixel Art‑Net Node EUROLITE DXT 70064851, Art‑Net to DMX bridge, 2 universes

EUROLITE DXT 70064851 is an Art‑Net to DMX bridge designed for pixel and stage lighting control. The unit receives Art‑Net data over a network and outputs DMX512 signal across two independent universes, allowing integration of networked lighting controllers with conventional DMX fixtures and pixel controllers. Compact and rack- or truss-mountable, this node is intended for installations, concerts and architectural lighting where stable conversion from Art‑Net to DMX is required.

Advantages

The device supports two DMX universes simultaneously, enabling control of multiple pixel strips or fixture groups from a single Art‑Net source. It provides reliable protocol conversion with low latency to preserve timing for pixel effects and synchronized cues. The unit’s Ethernet connectivity simplifies topology by using standard network infrastructure, and its compact enclosure makes it suitable for constrained spaces.

Suitable for

Key specifications

How to use

Connect the EUROLITE DXT unit to the Art‑Net network via Ethernet and configure the Art‑Net addressing to assign the desired universes. Link DMX outputs to your fixtures or pixel controllers using standard DMX cabling and terminate lines as required to ensure signal integrity. Use your lighting console or Art‑Net software to route channels to the two DMX universes handled by the node. Verify network settings and DMX output mapping during setup to ensure correct pixel ordering and fixture response.

Recommendations

Place the node near network switches or DMX distribution points to minimize cable runs. Use shielded Ethernet and DMX cabling where possible, and add proper termination and grounding for DMX lines. When deploying multiple nodes, ensure unique Art‑Net universe assignments to avoid data conflicts and monitor network bandwidth if many universes are present.